Cisco Cisco TelePresence MX700 Manuale Di Manutenzione
D15331.01 MX700 and MX800 Administrator Guide CE8.0, NOVEMBER 2015.
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
59
Cisco TelePresence MX700 and MX800
Administrator Guide
In order to use Touch 10 as user interface for MX700 and
MX800, Touch 10 must either be directly connected to
the video system as described on this page, or paired to
the video system via the network (LAN) as described on
the next page. The latter is referred to as remote pairing.
Connect Touch 10 directly to the video
system
Connect Touch 10 to the video system’s PoE injector as
illustrated.
Touch 10 set-up
Once Touch 10 is connected to power, the set-up
procedure begins. Follow the instructions on screen.
If Touch 10 needs software upgrade, new software will be
downloaded from the video system and installed on the
unit automatically as part of the set-up procedure. Touch
10 restarts after the upgrade.
Connect the Touch 10 controller
(page 1 of 3)
The Ethernet connector
is behind the lid at the
rear of Touch 10.
Contact information
The video system’s
name or address is
displayed in the top
banner when Touch
10 is successfully
connected to the video
system.
PoE rated Ethernet cable
Introduction
Configuration
Peripherals
Maintenance
System settings
Appendices
Peripherals