Cisco Cisco TelePresence MX700 Manuale Di Manutenzione

D15119.06 MX700 and MX800 Administrator Guide TC7.3, OCTOBER 2015.  

www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved. 

6

Cisco TelePresence MX700 and MX800 

Administrator Guide

What’s new  in this version

This section provides an overview of the new and changed 

system settings and new features in the TC7.3 software 

version.

Software release notes

For a complete overview of new features and changes, we 

recommend reading the Software Release Notes (TC7). Go 

to:

Software download

For software download go to: 

New features and improvements

Local preview of presentation in a call
This allows the user to preview the presentation locally before 

sharing it with far end. The feature has previously been 

available for EX systems, and is now available across the 

portfolio.

Multiple presentation outside a call
When the system is not in a call, it can simultaneously display 

multiple external sources on the connected screens, for 

example from two laptops.

Feature updates
Several feature improvements have been added to better 

align with C series functionality. There is now support for:

•  H323 / SIP dual registration
•  MultiWay
•  Additional audio call

Snap to Whiteboard feature
It is possible to configure a set up for a whiteboard scenario 

when using the SpeakerTrack 60. 

When the system detects a person speaking close to a 

whiteboard, the camera will go to a pre-defined preset 

covering the whiteboard area as defined by the administrator 

or installer.

There is a setup wizard for the Snap to Whiteboard feature in 

the administrator settings on the Touch 10. 

TC7.3.0-TC7.3.2: Users are notified when snapshots are 

taken
Both the on screen display and web interface have warnings 

when the snapshots feature is enabled. A notification pops up 

on the on screen display, when a snapshot is taken. On the 

web interface the administrator is warned that this notice will 

show up when the feature is enabled. 

The system also logs when snapshots are taken, and which IP 

address the request was initiated from. 

It is possible to allow and disallow snapshots remotely, but 

not to observe the room without the users being notified.

TC7.3.3 and later: Remote Monitoring option key
Due to security reasons, taking snapshots of local and far end 

video streams from the call control page on the system’s web 

interface now requires an option key to be installed on the 

endpoint.

The remote monitoring option key can only be added to 

systems that are upgraded to TC7.3.3 and above. Remote 

monitoring is enabled once the option key is added, and the 

system rebooted. Once this feature is enabled, the only way 

to disable it is to remove the option key. 

This feature does not display warning messages or indicators 

on the local system that someone is monitoring the room. 

Please provide adequate notice to users of the system that 

the system administrator may monitor and control the camera 

and screen.

New product
Cisco TelePresence MX800 Dual is supported from software 

version TC7.3.1.

Contents

Introduction

Web interface

System settings

Setting passwords

Appendices

Introduction