Cisco Cisco TelePresence MX700 Manuale Di Manutenzione

D15331.02 MX700 and MX800 Administrator Guide CE8.1, APRIL 2016.  

www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved. 

115

Cisco TelePresence MX700 and MX800

Administrator Guide

Network settings

Network [1] DNS Domain Name

The DNS Domain Name is the default domain name suffix which is added to unqualified 

names.
Example: If the DNS Domain Name is "company.com" and the name to lookup is 

"MyVideoSystem", this will result in the DNS lookup "MyVideoSystem.company.com".

Requires user role: ADMIN
Default value: ""

Value space: String (0, 64)

The DNS domain name.

Network [1] DNS Server [1..3] Address

Define the network addresses for DNS servers. Up to three addresses may be specified. 

If the network addresses are unknown, contact your administrator or Internet Service 

Provider.

Requires user role: ADMIN
Default value: ""

Value space: String (0, 64)

A valid IPv4 address or IPv6 address.

Network [1] IEEE8021X Mode

The system can be connected to an IEEE 802.1X LAN network, with a port-based network 

access control that is used to provide authenticated network access for Ethernet networks.

Requires user role: ADMIN
Default value: Off

Value space: Off/On

Off: The 802.1X authentication is disabled (default).
On: The 802.1X authentication is enabled.

Network [1] IEEE8021X TlsVerify

Verification of the server-side certificate of an IEEE802.1x connection against the 

certificates in the local CA-list when TLS is used. The CA-list must be uploaded to the 

video system. This can be done from the web interface.
This setting takes effect only when Network [1] IEEE8021X Eap Tls is enabled (On).

Requires user role: ADMIN
Default value: Off

Value space: Off/On

Off: When set to Off, TLS connections are allowed without verifying the server-side 

X.509 certificate against the local CA-list. This should typically be selected if no CA-list 

has been uploaded to the codec.
On: When set to On, the server-side X.509 certificate will be validated against the local 

CA-list for all TLS connections. Only servers with a valid certificate will be allowed.

Network [1] IEEE8021X UseClientCertificate

Authentication using a private key/certificate pair during an IEEE802.1x connection. The 

authentication X.509 certificate must be uploaded to the video system. This can be done 

from the web interface.

Requires user role: ADMIN
Default value: Off

Value space: Off/On

Off: When set to Off client-side authentication is not used (only server-side).
On: When set to On the client (video system) will perform a mutual authentication TLS 

handshake with the server.

Introduction

Configuration

Peripherals

Maintenance

System settings

Appendices



System settings