Cisco Cisco TelePresence MX700 Manuale Di Manutenzione
D15331.02 MX700 and MX800 Administrator Guide CE8.1, APRIL 2016.
www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved.
36
Cisco TelePresence MX700 and MX800
Administrator Guide
Set up secure audit logging
About secure audit logging
When audit logging is enabled, all sign in
activity and configuration changes on the
video system are recorded.
Use the
Security > Audit > Logging >
Mode
setting to enable audit logging.
Audit logging is disabled by default.
In ExternalSecure audit logging mode
the video system sends encrypted audit
logs to an external audit server (syslog
server), which identity must be verified by
a signed certificate.
The signature of the audit server is
verified using the same CA list as other
servers/clients.
If the audit server authentication fails, no
audit logs are sent to the external server.
1. Open the
Security
category.
2. Find the
Audit > Server
settings, and enter the
Address
of the audit server.
If you set
PortAssignment
to
Manual
,
you must also enter
a
Port
number for the audit
server.
Click
Save
for the changes
to take effect.
3. Set
Audit > Logging > Mode
to
ExternalSecure.
Click
Save
for the change to
take effect.
Sign in to the web interface, navigate to
Setup > Configuration
.
The certificate authority (CA) that verifies the certificate
of the audit server must be in the video system’s list of
trusted certificate authorities. Otherwise, logs will not be
sent to the external server.
Refer to the
chapter how to update the list.
Introduction
Configuration
Peripherals
Maintenance
System settings
Appendices
Configuration