Cisco Cisco TelePresence MX700 Manuale Di Manutenzione
D15331.02 MX700 and MX800 Administrator Guide CE8.1, APRIL 2016.
www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved.
51
Cisco TelePresence MX700 and MX800
Administrator Guide
MX700 and MX800 Dual support one external monitor, and
MX800 Single supports two external monitors, in addition to the
video systems’ integrated monitor(s).
The video system distributes the layout on all available monitors.
Always switch off power when you connect and
disconnect monitors and other peripherals.
Remove the video system’s left side cover to get access to the
codec connector panel and power switch. The cover is fastened
with magnets.
Do not disconnect the integrated monitors from the
codec, and do not use those connectors for anything else.
The reason for this is that the integrated monitor
connections make use of multichannel audio, which
drives the included speaker systems. Inserting third party
equipment is likely to break the audio chain, causing the
video system to fail from an audio perspective.
These connectors are used
for the integrated monitors.
Do not disconnect!
Connector 3 (DVI-I)
External monitor
Codec connector panel
Audio Line outputs
(Euroblock, 3.5 mm)
Connector 3 (DVI-I)
This connector is used for
the integrated monitor.
Do not disconnect!
External monitor
Codec connector panel
External monitor
Connector 2 (HDMI)
Audio Line outputs
(Euroblock, 3.5 mm)
MX700 and MX800 Dual
MX800 Single
Connect external monitors
(page 1 of 3)
Introduction
Configuration
Peripherals
Maintenance
System settings
Appendices
Peripherals