Cisco Cisco TelePresence MX700 Manuale Di Manutenzione

D15331.02 MX700 and MX800 Administrator Guide CE8.1, APRIL 2016.  

www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved. 

91

Cisco TelePresence MX700 and MX800

Administrator Guide

Audio settings

Audio DefaultVolume

Define the default volume for the speakers. The volume is set to this value when you switch 

on or restart the video system. Use the Touch controller to change the volume while the 

video system is running. You may also use API commands (xCommand Audio Volume) to 

change the volume while the video system is running, and to reset to default value.

Requires user role: ADMIN, USER
Default value: 50

Value space: Integer (0..100)

Select a value between 1 and 100. This corresponds to the dB range from -34.5 dB to 

15 dB, in steps of 0.5 dB). If set to 0 the audio is switched off.

Audio Microphones Mute Enabled

Define the microphone mute behaviour on the video system.

Requires user role: ADMIN
Default value: True

Value space: True/InCallOnly

True: Muting of audio is always available.
InCallOnly: Muting of audio is only available when the device is in a call. When Idle it is 

not possible to mute the microphone. This is useful when an external telephone service/

audio system is connected via the codec and is to be available when the codec is not 

in a call. When set to InCallOnly this will prevent the audio-system from being muted by 

mistake.

Audio SoundsAndAlerts RingTone

Define which ringtone to use for incoming calls.

Requires user role: ADMIN, USER
Default value: Sunrise

Value space: Sunrise/Mischief/Ripples/Reflections/Vibes/Delight/Evolve/Playful/Ascent/

Calculation/Mellow/Ringer

Select a ringtone from the list.

Audio SoundsAndAlerts RingVolume

Define the ring volume for incoming calls.

Requires user role: ADMIN, USER
Default value: 30

Value space: Integer (0..100)

The value goes in steps of 5 from 0 to 100 (from -34.5 dB to 15 dB). Volume 0 = Off.

Audio Input HDMI [n] Level

This setting applies to HDMI [2..3] for single camera systems, and to HDMI [3] for dual 

camera systems.
Define the audio level of the HDMI input connector, in steps of 1 dB.

Requires user role: ADMIN
Default value: 0

Value space: Integer (-24..0)

Select a value between -24 and 0, in steps of 1 dB.

Introduction

Configuration

Peripherals

Maintenance

System settings

Appendices



System settings