Cisco Cisco TelePresence MX700 Manuale Di Manutenzione

D15119.02 MX700 and MX800 Administrator Guide TC7.2, AUGUST 2014.

125

Cisco TelePresence MX700 and MX800

Administrator Guide

Connecting the Touch 10 user interface

The Touch 10 user interface must either be directly

connected to the MX700 or MX800 video system as

described on this page, or paired to the video system via the

network (LAN) as described on the next page. The latter is

referred to as remote pairing.

The procedures in this chapter apply to all MX700 and

MX800 video systems.

(page 1 of 2)

Connecting Touch 10 directly to the video

system

Connect Touch 10 to the video system’s PoE injector as

illustrated.

Touch 10 set-up
Once Touch 10 is connected, the set-up procedure begins.

Follow the instructions on screen.

If Touch 10 needs software upgrade, new software will be

downloaded from the video system and installed on the unit

automatically as part of the set-up procedure. Touch 10

restarts after the upgrade.

You can verify that Touch 10 is successfully connected to the

video system by checking that the video system's address is

displayed in the top banner.

Video system address

The Ethernet connector

is behind the lid at the

rear of Touch 10.

PoE rated Ethernet cable

Contents

Introduction

Web interface

System settings

Setting passwords

Appendices