Cisco Cisco TelePresence MX700 Manuale Di Manutenzione

D14850.13 MX200 and MX300 Administrator Guide TC7.3, OCTOBER 2015.

Cisco TelePresence MX200 and MX300

Administrator Guide

Network [1..1] RemoteAccess Allow

Define which IP addresses (IPv4/IPv6) are allowed for remote access to the codec from SSH/

Telnet/HTTP/HTTPS. Multiple IP addresses are separated by a white space.
A network mask (IP range) is specified by <ip address>/N, where N is 1-32 for IPv4, and N is

1-128 for IPv6. The /N is a common indication of a network mask where the first N bits are set.

Thus 192.168.0.0/24 would match any address starting with 192.168.0, since these are the first

24 bits in the address.

Requires user role: ADMIN
Value space: <S: 0, 255>

Format: String with a maximum of 255 characters.

Example:

Network 1 RemoteAccess Allow: "10.11.2.3 192.168.0.0/24 2001:0db8:0000:0000:0

000:ff00:0042:8329 2001:db8:abcd:0012::0/64"

Network [1..1] VLAN Voice Mode

Set the VLAN voice mode. The VLAN Voice Mode will be set to Auto automatically if you have

Cisco UCM (Cisco Unified Communications Manager) as provisioning infrastructure. Note that

Auto mode will NOT work if the NetworkServices CDP Mode setting is Off.

Requires user role: ADMIN
Value space: <Auto/Manual/Off>

Auto: The Cisco Discovery Protocol (CDP), if available, assigns an id to the voice VLAN. If

CDP is not available, VLAN is not enabled.
Manual: The VLAN ID is set manually using the Network VLAN Voice VlanId setting. If CDP is

available, the manually set value will be overruled by the value assigned by CDP.
Off: VLAN is not enabled.

Example:

Network 1 VLAN Voice Mode: Auto

Network [1..1] VLAN Voice VlanId

Set the VLAN voice ID. This setting will only take effect if VLAN Voice Mode is set to Manual.

Requires user role: ADMIN
Value space: <1..4094>

Range: Select a value between 1 and 4094.

Example:

Network 1 VLAN Voice VlanId: 1

Contents

Introduction

System settings

Setting passwords

Appendices

Web interface

System settings