Cisco Cisco TelePresence MX700 Manuale Di Manutenzione

D14850.08 MX200 and MX300 Administrator Guide TC7.0, DECEMBER 2013.

Cisco TelePresence MX200 and MX300

Administrator Guide

Network settings

Network [1..1] IPStack

Select if the sFystem should use IPv4, IPv6, or dual IP stack, on the network interface. NOTE:

After changing this setting you may have to wait up to 30 seconds before it takes effect.

Requires user role: ADMIN
Value space: <Dual/IPv4/IPv6>

Dual: When set to Dual, the network interface can operate on both IP versions at the same

time, and can have both an IPv4 and an IPv6 address at the same time.
IPv4: When set to IPv4, the system will use IPv4 on the network interface.
IPv6: When set to IPv6, the system will use IPv6 on the network interface.

Example:

Network 1 IPStack: Dual

Network [1..1] IPv4 Assignment

Define how the system will obtain its IPv4 address, subnet mask and gateway address. This

setting only applies to systems on IPv4 networks.

Requires user role: ADMIN
Value space: <Static/DHCP>

Static: The addresses must be configured manually using the Network IPv4 Address,

Network IPv4 Gateway and Network IPv4 SubnetMask settings (static addresses).
DHCP: The system addresses are automatically assigned by the DHCP server.

Example:

Network 1 IPv4 Assignment: DHCP

Network [1..1] IPv4 Address

Enter the static IPv4 network address for the system. This setting is only applicable when

Network Assignment is set to Static.

Requires user role: ADMIN
Value space: <S: 0, 64>

Format: A valid IPv4 address.

Example:

Network 1 IPv4 Address: "192.0.2.2"

Network [1..1] IPv4 Gateway

Define the IPv4 network gateway. This setting is only applicable when the Network Assignment

is set to Static.

Requires user role: ADMIN
Value space: <S: 0, 64>

Format: A valid IPv4 address.

Example:

Network 1 IPv4 Gateway: "192.0.2.1"

Network [1..1] IPv4 SubnetMask

Define the IPv4 network subnet mask. This setting is only applicable when the Network

Assignment is set to Static.

Requires user role: ADMIN
Value space: <S: 0, 64>

Format: The valid IPv4 address format.

Example:

Network 1 IPv4 SubnetMask: "255.255.255.0"

Network [1..1] IPv6 Assignment

Define how the system will obtain its IPv6 address and the default gateway address. This

setting only applies to systems on IPv6 networks.

Requires user role: ADMIN
Value space: <Static/DHCPv6/Autoconf>

Static: The codec and gateway IP addresses must be configured manually using the Network

IPv6 Address and Network IPv6 Gateway settings. The options, for example NTP and DNS

server addresses, must either be set manually or obtained from a DHCPv6 server. The

Network IPv6 DHCPOptions setting determines which method to use.
DHCPv6: All IPv6 addresses, including options, will be obtained from a DHCPv6 server. See

RFC 3315 for a detailed description. The Network IPv6 DHCPOptions setting will be ignored.
Autoconf: Enable IPv6 stateless autoconfiguration of the IPv6 network interface. See RFC

4862 for a detailed description. The options, for example NTP and DNS server addresses,

must either be set manually or obtained from a DHCPv6 server. The Network IPv6

DHCPOptions setting determines which method to use.

Example:

Network 1 IPv6 Assignment: Autoconf

Contents

Introduction

System settings

Setting passwords

Appendices

Web interface

System settings