Cisco Cisco TelePresence MX700 Manuale Di Manutenzione
D14850.05 MX Series Administrator Guide TC6.1, APRIL 2013.
www.cisco.com — Copyright © 2011–2013 Cisco Systems, Inc. All rights reserved.
104
Cisco TelePresence MX Series
Administrator Guide
Reset
button
Touch
Web
Factory resetting
If you have to reset your video system to its default factory
settings, we recommend that you use either the Touch
controller or the web interface. If neither of these methods
are available, you can use the video system’s reset button.
When factory resetting the video system the following
happens:
• Call logs will be deleted.
• Passwords will be reset to default.
• All system parameters will be reset to default values.
• All files that have been uploaded to the system will be
• Passwords will be reset to default.
• All system parameters will be reset to default values.
• All files that have been uploaded to the system will be
deleted. This includes, but is not limited to, custom
backgrounds, certificates, the favorites list and the
inactive software image.
• Release keys and option keys will
not be affected.
• The system restarts automatically after the reset.
It is not possible to undo a factory reset.
1. Remove the video system’s back cover.
2. Use the tip of a pen (or similar) to press and hold the
recessed reset button until the screen turns black
(approximately 10 seconds). Then release the button.
The system reverts to the default factory settings and
The system reverts to the default factory settings and
restarts automatically. This will take a few minutes.
The system confirms the factory reset by displaying a
notification on the main screen when up and running
again. The notification disappears after approximately
10 seconds.
1. Tap gently on the Touch screen if the unit is in sleep
mode.
2. Navigate to
Settings ( ) > Administrator Settings >
Reset.
3. Tap the
Factory Reset
button.
The system reverts to the default factory settings and
restarts automatically. This will take a few minutes.
The system confirms the factory reset by displaying a
notification on the main screen when up and running
again. The notification disappears after approximately
10 seconds.
Tap
Settings ( ) > System Information
on the Touch
controller to find the system's IP address (IPv4
or IPv6).
1. Open a web browser and enter the IP address of the
video system in the address bar.
2. Navigate to
Maintenance > Factory Reset
.
3. Read the provided information carefully before you click
Perform a factory reset
.
4. If you are sure you want to perform a factory reset, click
the red
Reset
button.
The system reverts to the default factory settings and
restarts automatically. This will take a few minutes.
The system confirms the factory reset by displaying a
notification on the main screen when up and running
again. The notification disappears after approximately
10 seconds.
Lift this handle to lock/
unlock the back cover.
Similar function also on
table stand and wall mount
options.
Reset button
The recessed button can be quite
The recessed button can be quite
difficult to use. You should feel the
button go down when pushed.
If you want to backup your current configuration
before you factory reset the unit, open a web browser
and follow these steps:
• Enter the IP address of the video system in the
address bar and sign in.
• Navigate to
Maintenance > Backup and Restore
.
• Click
Take backup
and follow the instructions to
save the file on your computer.
Contents
Introduction
System settings
Setting passwords
Appendices
Web interface
Appendices