Cisco Cisco TelePresence MX700
New feature and functionality descriptions CE8.3.0
18
New feature and functionality descriptions
CE8.3.0
New features enabled for Cisco DX70 and DX80
Wi-Fi support
Wi-Fi support has been enabled in CE8.3.0 for Cisco DX70 and DX80 systems that are shipped with a
built-in Wi-Fi adapter.
Supported IEEE standards
Supported security protocols
IEEE802.11n, IEEE802.11a, IEEE802.11g,
IEEE802.11b
WPA-PSK (TKIP/AES), WPA2-PSK (AES)
Support for additional enterprise security protocols will come in a later Collaboration Endpoint
Software release.
Access the network settings in the on-screen user interface to connect to a wireless network. In order
to use Wi-Fi, you must disconnect the Ethernet cable if connected. A notification will be displayed if
the system detects that you are connected with an Ethernet cable and that you cannot proceed until
you have disconnected the Ethernet cable.
Ethernet will always take precedence over Wi-Fi if connected.
If the network you are trying to connect to is not supported it will be displayed on-screen, the DX
system does not support the security protocol for that network.
Intelligent Proximity support
Intelligent Proximity is now supported on the Cisco DX70 and DX80 in alignment with other endpoints
running Collaboration Endpoint software. The feature is disabled by default and must be enabled in
the configuration. Cisco only supports one endpoint per room that has Proximity enabled. Multiple
systems transmitting ultrasound in close proximity of one another causes noise and unstable pairing
conditions.
All the Proximity services, wireless sharing, receive content and endpoint control via the Proximity
clients are supported with the DX systems. Please note that paired devices will only be able to
receive content when shared to the far-end in a call, if the content is “previewed” it will not be sent to
the paired devices regardless if the content is previewed inside or outside of a call due to privacy
concerns.