Cisco Cisco Cius Wi-Fi Guida Alla Progettazione
Cisco Cius Wireless Deployment Guide
88
Tkip MIC Countermeasure Hold-down Timer....... 60
For the Cisco Autonomous Access Point, enter the time in seconds to holdoff clients if a TKIP countermeasure event occurs.
Interface dot11radio X
countermeasure tkip hold-time <nseconds>
VLANs and Cisco Autonomous Access Points
Segment wireless voice and data into separate VLANs.
A subnet for wireless clients should not exceed 1,000 hosts.
When using Cisco Autonomous Access Points, use a dedicated native VLAN. The Cisco Autonomous Access Points utilize
Inter-Access Point Protocol (IAPP), which is a multicast protocol.
For the native VLAN, it is recommended not to use VLAN 1 to ensure that IAPP packets are exchanged successfully.
Ensure that Public Secure Packet Forwarding (PSPF) is not enabled for the voice VLAN as this will prevent clients from
communicating directly when associated to the same access point. If PSPF is enabled, then the result will be no way audio.
Port security should be disabled on switch ports that Cisco Autonomous Access Points are directly connected to.
A subnet for wireless clients should not exceed 1,000 hosts.
When using Cisco Autonomous Access Points, use a dedicated native VLAN. The Cisco Autonomous Access Points utilize
Inter-Access Point Protocol (IAPP), which is a multicast protocol.
For the native VLAN, it is recommended not to use VLAN 1 to ensure that IAPP packets are exchanged successfully.
Ensure that Public Secure Packet Forwarding (PSPF) is not enabled for the voice VLAN as this will prevent clients from
communicating directly when associated to the same access point. If PSPF is enabled, then the result will be no way audio.
Port security should be disabled on switch ports that Cisco Autonomous Access Points are directly connected to.
The network ID in the SSID configuration with the Cisco Autonomous Access Point should only be disabled if Layer 3 mobility
is enabled where the Wireless LAN Services Module (WLSM) is deployed.
is enabled where the Wireless LAN Services Module (WLSM) is deployed.
Configuring Cisco Cius
To configure the Wi-Fi settings on Cisco Cius, use the keypad and touch screen to navigate to Settings > Wireless & networks
> Wi-Fi settings.
> Wi-Fi settings.
Setup Assistant
When first powering on Cisco Cius, the Setup Assistant will be launched to help guide the user through the services
configuration.
Select the service to start the configuration process.
configuration.
Select the service to start the configuration process.
• WiFi
• Email
• Chat
• WebEx
• Voice Messages
• Chat
• WebEx
• Voice Messages
A checkmark will be displayed when the service has been successfully configured.