Cisco Cisco Firepower Management Center 2000 Guida All'Installazione
3-4
Cisco NGIPS for Blue Coat X-Series Installation and Configuration Guide
Chapter 3 Installing Cisco NGIPS for Blue Coat X-Series
Preparing for the Installation
SDRAM 2 Size 0(KB)
SDRAM 3 Size 1048576(KB)
SDRAM 4 Size 0(KB)
SDRAM Total Size 2097152(KB)
Reserved Memory 0(KB)
Total Memory 2097152(KB)
Used Memory 1815924(KB)
Free Memory 218228(KB)
Shared Memory 0(KB)
Buffers Memory 0(KB)
Cached Memeory 91344(KB)
Memory Utilization 82.23%
Step 1
To determine which APM is associated with which slot, enter the following:
CBS# show chassis
The system displays the chassis configuration similar to the information in the sample below:
Slot Present Module Name Module Type Status Uptime
1 Yes np1 NPM9610 Up 119 days, 02:56
2 No n/a n/a n/a
3 No n/a n/a n/a
4 No n/a n/a n/a
5 Yes ap3 APM9600 Active 119 days, 02:40
6 Yes ap4 APM9600 Active 119 days, 02:42
Creating and Configuring a VAP Group
The series of commands detailed in the following procedure creates a VAP group named
ABC
where the
max-load-count
value of 2 limits the active VAPs in the VAP group to two, and the
available-ap-list
specifies three VAPs which the VAP group can use (two VAPs host the active VAPs and you reserve the
third for failover):
third for failover):
CBS# configure vap-group ABC xslinux_v5_64
CBS(config-vap-grp)# vap-count 2
CBS(config-vap-grp)# max-load-count 2
CBS(config-vap-grp)# available-ap-list ap1 ap2 ap5
CBS(config-vap-grp)# ip-flow-rule Inline_lb
CBS(ip-flow-rule)# action load-balance
CBS(ip-flow-rule)# activate
CBS(ip-flow-rule)# end
CBS#
To create and configure a VAP group:
Step 1
Create a VAP group by entering the following at the CLI prompt:
CBS# configure vap-group vap_group_name xslinux_v5_64
where
vap_group_name
is the name you want to give to the VAP group.
For example, to create a VAP group named ABC, enter the following command at the CLI prompt:
CBS# configure vap-group ABC xslinux_v5_64
You must verify that you want to create the new VAP group. The creation process takes several minutes.
Step 2
Set the
vap-count
and
max-load-count
to the same value for this VAP group by entering the following
commands separately and in this sequence:
CBS(config-vap-grp)# vap-count vap-count-quantity
CBS(config-vap-grp)# max-load-count max-load-quantity
where
vap-count-quantity
is the number of VAPs you want to create for the VAP group, and
max-load-quantity
is the maximum number of VAPs the VAP group can contain.