Cisco Cisco Firepower Management Center 2000 Guida Dello Sviluppatore
Version 5.3
Sourcefire 3D System eStreamer Integration Guide
411
Configuring eStreamer
Configuring eStreamer on the eStreamer Server
Chapter 6
17. Type
0
and press Enter to exit the script.
At this point, eStreamer will send information out via the
eth1
interface
rather than
eth0
.
WARNING!
The script can be run to configure eStreamer to use the
eth1
interface even if the
eth1
interface is not connected. However, eStreamer
cannot stream data over the interface unless the eStreamer client is on a host
that is reachable from that interface.
To configure eStreamer to use the primary management interface
A
CCESS
: Root
1. Open an SSH connection to the Defense Center.
2. Log into the Defense Center.
2. Log into the Defense Center.
3. Type
sudo su
to get root access. If necessary, type your password again
when prompted.
4. Type the command
manage_estreamer.pl
to start the eStreamer
configuration utility. This will bring up the following menu:
**************** Configuration Utility **************
1 status
2 disable
3 enable
4 restart
5 send IDS events
6 don't send IDS events
7 send Packet Data
8 don't send Packet Data
9 add Client
10 delete Client
11 set EStreamer Interface
0 Exit
************************************************************
Enter choice:
**************** Configuration Utility **************
5. Type choice
11
and press Enter.