Cisco Cisco Content Security Management Appliance M1070 Guida Utente
2-9
AsyncOS 9.0 for Cisco Content Security Management Appliances User Guide
Chapter 2 Setup, Installation, and Basic Configuration
Running the System Setup Wizard
Warning
The Security Management appliance ships with a default IP address of
192.168.42.42
on the
Management port. Before connecting the Security Management appliance to your network, ensure
that no other device’s IP address conflicts with the factory default setting.
that no other device’s IP address conflicts with the factory default setting.
Note
By default, your session times out if you are idle for more than 30 minutes or if you close the browser
without logging out. If the session times out while you are running the System Setup Wizard, you need
to start over from the beginning.
without logging out. If the session times out while you are running the System Setup Wizard, you need
to start over from the beginning.
To change the session timeout limit, see
Note
By default, your session times out if you are idle for more than 30 minutes or if you close the browser
without logging out. If this happens, you must reenter your user name and password. If the session times
out while you are running the System Setup Wizard, you need to start over from the beginning. To change
the timeout limit, see
without logging out. If this happens, you must reenter your user name and password. If the session times
out while you are running the System Setup Wizard, you need to start over from the beginning. To change
the timeout limit, see
.
Overview of the System Setup Wizard
Procedure
Step 1
Step 2
Step 3
•
Notification settings and AutoSupport
•
System time settings
•
Admin password
Step 4
•
Hostname of the appliance
•
IP address, network mask, and gateway of the appliance
•
Default router and DNS settings
Step 5
Proceed through the wizard pages, and carefully review your configuration at step 4. You can return to
a step by clicking Previous. At the end of the process, the wizard prompts you to commit the changes
that you have made. Most changes do not take effect until you commit them.
a step by clicking Previous. At the end of the process, the wizard prompts you to commit the changes
that you have made. Most changes do not take effect until you commit them.
Step 6