Cisco Cisco Content Security Management Appliance M1070 Guida Utente

Use the 

loadconfig

 command to load new configuration information into the 

Cisco IronPort appliance. You can load information using one of two methods: 

Placing information in the 

configuration

 directory and uploading it 

Pasting configuration information directly into the CLI

See 

 for more information.

Use the 

publishconfig

 command to publish changes a configuration master. The 

syntax is as follows:

publishconfig config_master [job_name] [host_list | host_ip 

where config_master is either 5.7, 6.3, or 7.1. This keyword is required. The 
keyword job_name is optional and will be generated if it is not specified.

The keyword host_list is a list of host names or IP addresses for WSA appliances 
to be published, and will be published to all hosts assigned to the configuration 
master if not specified. The optional host_ip can be multiple host IP addresses, 
each separated by a comma.

To verify that the 

publishconfig 

command was successful, check the 

smad_logs

 

file. You can also verify that the publish history was successful from the Security 
Management appliance GUI by choosing Web > Utilities > Web Appliance 
Status. From this page choose the web appliance that you want the publish history 
details. Additionally, you can go the Publish History page: Web > Utilities > 
Publish > Publish History.

Use the 

backupconfig

 command to copy the active dataset from the ‘source’ 

appliance to a ‘target’ Security Management appliance with minimum disruption 
on the originating ‘source’ Security Management appliance. 

For more information on this command, the usage, and backing up your dataset, 
see