Cisco Cisco Content Security Management Appliance M390 Guida Utente

In this example, a new configuration file is pasted directly at the command line. 
(Remember to press Ctrl-D on a blank line to end the paste command.) Then the 
System Setup Wizard is used to change the default hostname, IP address, and 
gateway information. (For more information, see 

.) Finally, the changes are committed. 

mail3.example.com> loadconfig

1. Paste via CLI

2. Load from file

[1]> 1

Paste the configuration file now. Press CTRL-D on a blank line when done.

[The configuration file is pasted until the end tag 

</config>

. Control-D 

is entered on a separate line.] 

Values have been loaded.

Be sure to run "commit" to make these settings active.

mail3.example.com> commit

Please enter some comments describing your changes:

[]> pasted new configuration file and changed default settings