Cisco Cisco IOS Software Releases 12.2 MC

To collect data for reporting router issues, issue the following command:

show tech-support—Displays general information about the router when it reports a problem.

To collect data for redundancy-related issues, issue the following commands while in EXEC mode:

show redundancy—Displays current or historical status and related information on redundant Dial 
Shelf Controllers (DSCs).

show controllers—Displays information that is specific to the hardware.

show standby—Displays Hot Standby Router Protocol (HSRP) information.

show ip interface—Displays the usability status of interfaces configured for IP.

To collect data for ROMmon issues, issue the following command while in EXEC mode:

showmon— Displays currently selected ROM monitor.

If a router reboot to ROMmon occurs, issue the dir device ID command where device ID is slot0:, and 
look for the router processor or network processor exception file (crashinfo* or pxf_crashinfo* 
respectively). Once you have located one of these files, you can email the file along with a description 
of the problem to your Cisco representative.

 

This section contains information that was not included or was documented incorrectly in the Cisco 
MWR 1900 Software Configuration Guide. The heading in this section corresponds with the applicable 
section title in the documentation.

The maximum number of RTP header compression connections per MLP bundle is documented as 600 
when in fact, up to 1000 connections are supported on an interface. This amendment also applies to the 
ip rtp header-compression command description.

The detail keyword is not supported in the show ip rtp header-compression command. Therefore, 
output does not display for the 

 keyword if specified in command.