Cisco Cisco IOS Software Release 12.2(33)SRE
735
Caveats for Cisco IOS Release 12.2(33)SRC through 12.2(33)SRC6
OL-10394-05 Rev. R0
•
CSCtb64636
Symptoms: SPA_CHOC_DSX-3-HDLC_CTRL_ERR messages are seen continuously with any
channelized SPA with full channelization with MLP bundles with C7600-sip-400 linecard. There is
some traffic outage due to this.
channelized SPA with full channelization with MLP bundles with C7600-sip-400 linecard. There is
some traffic outage due to this.
Conditions: Occurs when the following conditions are: present:
1. SPA should be fully channelized.
2. There should be some MLP bundles, and the traffic should be at the near to the line rate of the
SPA.
SPA.
3. Member links are flapping continuously for approximately 2 hours.
Workaround: Perform a shut/no shut on the bundle from which the member links are flapping.
Resolved Caveats—Cisco IOS Release 12.2(33)SRC4
Cisco IOS Release 12.2(33)SRC4 is a rebuild release for Cisco IOS Release 12.2(33)SRC. The caveats
in this section are resolved in Cisco IOS Release 12.2(33)SRC4 but may be open in previous Cisco IOS
releases.
in this section are resolved in Cisco IOS Release 12.2(33)SRC4 but may be open in previous Cisco IOS
releases.
•
CSCee19691
Symptoms: A Cisco router may crash when you enter the clear ip route * command multiple times.
Conditions: This symptom is observed on a Cisco router that runs Cisco IOS Release 12.2S or
Release 12.3 and that is configured for RIP.
Release 12.3 and that is configured for RIP.
Workaround: There is no workaround.
•
CSCee72833
Symptoms: Cisco 7200/NPE-G1 router running Cisco IOS Release 12.3(5c) hangs during reload.
Conditions: Occurs if AUX port is connected to console port of Catalyst 3550.
Workaround: Disconnect cable from AUX port
•
CSCeg35237
Symptoms: Watchdog timeout crash when using the show crypto session command.
Conditions: Occurs on a Cisco 7200 NPE-G1 running Cisco IOS Release 12.3(7)T2 and Cisco IOS
Release 12.3(8)T1.
Release 12.3(8)T1.
Workaround: There is no workaround.
•
CSCeh04362
Symptoms: RBE does not function in an IPv6 environment
Conditions: This problem is seen with the 12.2(27)SB images. Traffic does not pass through with
RBE configured for IPv6.
RBE configured for IPv6.
Workaround: There is no workaround.
•
CSCei59800
Symptoms: The commands configure include all policy-map command does not include the
policy-map mode commands as part of the view.
policy-map mode commands as part of the view.
Conditions: Occurs on a Cisco router running Cisco IOS Release 12.4T.
Workaround: There is no workaround.