Cisco Cisco IOS Software Release 12.2(55)SE
17
Release Notes for the Cisco IE 3000 Switch, Cisco IOS Release 12.2(55)SE and Later
OL-23061-05
Resolved Caveats
entered, the
Device mode already VTP Transparent for MST
message is displayed. Now if the
master switch is reloaded, the whole stack is shown as the primary server for both the VLAN and
the MST.
the MST.
The workaround is to change the VTP version to 2 and then change it back again to 3.
•
CSCtd62339
The following error is seen when EIGRP is enabled on the switch:
%EIGRP: Failed to get client
handle from BFD
There is no workaround.
•
CSCti88809
If Smart Install is enabled and the shutdown command is entered on a range of interfaces followed
by the no shutdown command, a traceback is seen due to data corruption.
by the no shutdown command, a traceback is seen due to data corruption.
The workaround is to disable Smart Install by entering the no vstack global configuration command.
•
CSCtr24525
The value of the logmessageperiod command in the Precision Time Protocol (PTP) announce
packet shows the erroneous value of 127.
packet shows the erroneous value of 127.
There is no workaround.
Caveats Resolved for Cisco IOS Release 12.2(55)SE8
•
CSCtt19737
Cisco IOS IP SLAs probes fail because the control message is blocked. The firewalls block the
control message when a response packet is not returned to the originating port.
control message when a response packet is not returned to the originating port.
The workaround is to disable IP SLAs control messages for this probe instance.
•
CSCty66157
The snmp-server group command does not associate both IPv6 and IPv4 ACLs simultaneously
with an SNMP group.
with an SNMP group.
The workaround is to use the snmp-server user command, which associates both IPv4 and IPv6
ACLs with an SNMP user.
ACLs with an SNMP user.
•
CSCud79753
When a switch is configured with Cisco IOS IP SLAs FTP GET operation and if the target file is
unavailable, the switch experiences a memory leak and may become unresponsive if it runs out of
memory.
unavailable, the switch experiences a memory leak and may become unresponsive if it runs out of
memory.
The workaround is to configure the Cisco IOS IP SLAs FTP GET operation only after verifying the
availability of the remote target file and setting the permissions for the file, as appropriate. This
allows the switch to retrieve the file and not experience a memory leak.
availability of the remote target file and setting the permissions for the file, as appropriate. This
allows the switch to retrieve the file and not experience a memory leak.
•
CSCue07405
When manually running on-demand diagnostic tests on a stack member using the diagnostic start
switch number test all interface configuration command, the test TestPortAsicRingLoopback fails
arbitrarily.
switch number test all interface configuration command, the test TestPortAsicRingLoopback fails
arbitrarily.
The workaround is to run only the TestPortAsicRingLoopback test (diagnostic start switch number
test 4 interface configuration command) on the stack member. Isolate the stack member and then
run the diagnostic start switch number test all interface configuration command on the rest of the
stack.
test 4 interface configuration command) on the stack member. Isolate the stack member and then
run the diagnostic start switch number test all interface configuration command on the rest of the
stack.