Cisco Cisco IPS 4255 Sensor Guida All'Installazione
13
Removing and Installing Interface Cards in Cisco IPS-4260 and IPS 4270-20
78-19056-01
Installing Interface Cards in IPS 4270-20
Step 9
Slide the chassis cover back and up to remove it.
Caution
Do not operate IPS 4270-20 without the chassis cover installed. The chassis cover protects the internal
components, prevents electrical shorts, and provides proper air flow for cooling the electronic
components.
components, prevents electrical shorts, and provides proper air flow for cooling the electronic
components.
Step 10
To replace the chassis cover, position it on top of the chassis and slide it on. Push down on the cover
latch to lock into place.
latch to lock into place.
Note
Make sure the chassis cover is securely locked in to place before powering up IPS 4270-20.
Step 11
Reattach the power cables to IPS 4270-20.
Step 12
Reinstall IPS 4270-20 in a rack, on a desktop, or on a table, or extend it back in to the rack.
Step 13
Power on IPS 4270-20.
For More Information
For the procedure for removing IPS 4270-20 from a rack, refer to “Installing IPS 4270-20,” in
Installing and Removing Interface Cards
IPS 4270-20 has nine expansion card slots. Slots 1 and 2 are PCI-X slots and are reserved for future use.
Slots 3 through 9 are PCI-Express slots. All slots are full-height slots. Slot 9 is populated by a RAID
controller card and is not available for use by network interface cards.
Slots 3 through 9 are PCI-Express slots. All slots are full-height slots. Slot 9 is populated by a RAID
controller card and is not available for use by network interface cards.
Note
IPS 4270-20 supports two 10GE fiber interface cards, which you can install in any of the supported six
slots (slots 3 to 8).
slots (slots 3 to 8).
1
2
3
4
5
6
7
8
250124
1
2
3
4
5
6
7
8
Cisco IPS 4270 SER
IES
Intrusio
n Prevention
Sensor
UID SY
ST
EM
PWR ST
ATUS
MGMT 0
MG
MT
1