Cisco Cisco ASA 5515-X Adaptive Security Appliance - No Payload Encryption

If ASDM loads an existing running configuration and finds IPv6-related commands, ASDM 
displays a dialog box informing you that it does not support IPv6. You cannot configure any IPv6 
commands in ASDM, but all other configuration is available.

If ASDM loads an existing running configuration and finds other unsupported commands, ASDM 
operation is unaffected. To view the unsupported commands, choose Tools > Show Commands 
Ignored by ASDM on Device.

If ASDM loads an existing running configuration and finds the alias command, it enters 
Monitor-only mode.

Monitor-only mode allows access to the following functions: 

The Monitoring area

The CLI tool (Tools > Command Line Interface), which lets you use the CLI commands

To exit Monitor-only mode, use the CLI tool or access the adaptive security appliance console, and 
remove the alias command. You can use outside NAT instead of the alias command. See the Cisco 
Security Appliance Command Reference for more information.

You might also be in Monitor-only mode because your user account privilege level, indicated in 
the status bar at the bottom of the main ASDM window, was set up as less than or equal to three 
by your system administrator, which allows Monitor-only mode. For more information, choose 
Configuration > Device Management > Users/AAA > User Accounts and 
Configuration > Device Management > Users/AAA > AAA Access. 

ASDM does not support discontinuous subnet masks such as 255.255.0.255. For example, you cannot 
use the following:

ip address inside 192.168.2.1 255.255.0.255

The ASDM CLI tool does not support interactive user commands. If you enter a CLI command that 
requires interactive confirmation, ASDM prompts you to enter “[yes/no]” but does not recognize your 
input. ASDM then times out waiting for your response. 

Ignored

Ignored

Ignored