Cisco Cisco 5760 Wireless LAN Controller Riferimenti tecnici
• If you try to enable IEEE 802.1x on a dynamic-access (VLAN Query Protocol [VQP]) port, an error
message appears, and IEEE 802.1x is not enabled. If you try to change an IEEE 802.1x-enabled port to
dynamic VLAN assignment, an error message appears, and the VLAN configuration is not changed.
dynamic VLAN assignment, an error message appears, and the VLAN configuration is not changed.
You can verify your settings by entering the show interfaces interface-id switchport privileged EXEC
command and examining information in the Administrative Mode and Operational Mode rows.
command and examining information in the Administrative Mode and Operational Mode rows.
Examples
This example shows how to configure a port for access mode:
Controller(config)#
interface gigabitethernet2/0/1
Controller(config-if)#
switchport mode access
This example shows how set the port to dynamic desirable mode:
Controller(config)#
interface gigabitethernet2/0/1
Controller(config-if)#
switchport mode dynamic desirable
This example shows how to configure a port for trunk mode:
Controller(config)#
interface gigabitethernet2/0/1
Controller(config-if)#
switchport mode trunk
This example shows how to configure a port as an IEEE 802.1Q tunnel port:
Controller(config)#
interface gigabitethernet2/0/1
Controller(config-if)#
switchport mode dot1q-tunnel
Related Commands
Description
Command
Configures a port as a static-access or dynamic-access port.
Consolidated Platform Command Reference, Cisco IOS XE Release 3SE (Cisco WLC 5700 Series)
510
OL-29471-01
switchport mode