Cisco Cisco 4402 Wireless LAN Controller Guida All'Installazione
7
Required Tools and Information
You will need the following tools and information before you can install the controller:
•
Wireless LAN controller hardware
–
Controller with factory-supplied power cord and mounting hardware
–
Network, operating system service network, and access point cables as required
•
Command-line interface (CLI) console
–
VT-100 terminal emulator on CLI console (PC, laptop, or palmtop)
–
CISCO console port cable (RJ-45 to DB-9) and modular adapter (RJ-45 female to DB-9
female) to connect CLI console and controller
female) to connect CLI console and controller
•
Local TFTP server (required for downloading operating system software updates). Cisco uses an
integral TFTP server. This means that third-party TFTP servers cannot run on the same
workstation as the Cisco WCS because Cisco WCS and third-party TFTP servers use the same
communication port.
integral TFTP server. This means that third-party TFTP servers cannot run on the same
workstation as the Cisco WCS because Cisco WCS and third-party TFTP servers use the same
communication port.
Initial System Configuration Information
Obtain the following initial configuration parameters from your wireless LAN or network
administrator:
administrator:
•
A system (controller name).
•
An administrative username and password. The default administrative username and password
are admin and admin, respectively.
are admin and admin, respectively.
•
A service port interface IP address configuration protocol (none or DHCP).
•
A management interface (DS Port or network interface port) IP address.
Note
The service port interface and management interface must be on different subnets.
•
A management interface netmask address.
•
A management interface default router IP address.
•
A VLAN identifier if the management interface is assigned to a VLAN, or 0 for an untagged
VLAN.
VLAN.
•
Distribution system physical port number
–
4402: 1–2 for front panel GigE ports
–
4404: 1–4 for front panel GigE ports
•
IP address of the default DHCP server that will supply IP addresses to clients.