Cisco Cisco TelePresence MX700 Guida All'Installazione

1. 

Configuring H.323 and SIP

(when not set by a provisioning system)

to get online and ready to place and receive calls, your system 

must be set up properly. Your system uses either the H.323 

protocol or the SiP protocol for video calls.

NoTe:

 Contact your system administrator, or service provider, 

for information about the network settings.

for networks administered through Cisco tMS (Cisco 

telePresence Management Suite) your Cisco tMS adminis-

trator will help you to get online.

You can find information about admininistering through Cisco 

uCM in the 

 guide.

H.323

if in doubt about any of the parameters below, contact your 

system administrator or your service provider.

1. tap 

. 

2. enter the 

and 

in their respective 

input fields.

3. if you want to enter the address of the H.323 gatekeeper 

manually, tap 

 in the 

section, 

and enter the 

 in the input field. 

otherwise tap 

.

4. if the H.323 gatekeeper requires authentication and you 

want your system to authenticate itself to the gatekeeper, 

tap 

 in the 

 section and enter the 

and 

 in their respective input fields. 

otherwise, tap 

.

5. tap 

 to save the changes, or 

 to leave without 

saving.

6. review the System information page and verify the H323 

settings.

if you successfully registered to the Gatekeeper the 

is shown as 

in the H323 section.

7. tap 

 to return to the home menu.

SIP

if in doubt about any of the parameters below, contact your 

system administrator or your service provider.

1. tap 

. 

2. enter the SiP uri in the 

 input field.

3. tap the preferred transport protocol in the 

section. if you select 

, the system first tries to connect 

using tlS, then tCP, and finally udP.

4. Select a 

. Step through the list of available 

proxy types by tapping the - or + signs. the default type 

is 

.

5. if you want to enter the SiP proxy address manually, tap 

 in the

 section and enter the

 in the input field. if you want the system to obtain 

the SiP proxy address automatically (dHCP), tap 

.

6. if the SiP proxy server requires authentication you must 

enter the 

and 

 in their respective 

input fields to authenticate your system.

7. tap 

 to save the changes, or 

 to leave without 

saving.

8. review the System information page and verify the SiP 

settings.

if you successfully registered to a SiP server the 

 is 

shown as 

in the SiP section.

9. tap 

 to return to the home menu.

Back to task overview

Cisco TelePresence Video Systems

D14639.09 Video Systems Getting Started Guide TC6.1, April 2013. 

Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved. 

15

Getting Started Guide

Contents

Introduction

User interfaces

Configuration

Appendices

Contacts

Confirguration