Cisco Cisco TelePresence MX700 Nota Di Rilascio
Resolved caveats
Cisco TelePresence System C-Series Software Release Notes
Page 21 of 36
Reference ID
Summary
CSCts28171
C/EX-series endpoints lose audio while attending MCU conference with
interworking encrypted calls.
interworking encrypted calls.
CSCtr25756
TC based software is unable to register with a Huawei IMS system
CSCto14930
When placing C-series to C-series calls via SBC (Session Border Controller) with
H.323 or SIP. The C-series uses RTCP payload specific updates for fast update
request. These updates are not RFC 3550 compliant and are blocked by the SBC.
H.323 or SIP. The C-series uses RTCP payload specific updates for fast update
request. These updates are not RFC 3550 compliant and are blocked by the SBC.
CSCtu49826
A C-Series system will report "Can not connect call" when dialing a second site
before the first site has connected.
before the first site has connected.
CSCtt14526
The Cisco CTS C20 looses main video from a RadVision Scoopia MCU when the
C20 starts presentation (dual channel).
C20 starts presentation (dual channel).
CSCtu13714
If the network MultiWay protocol is set to auto and the default protocol is set to
SIP, MultiWay will not be initiated.
SIP, MultiWay will not be initiated.
CSCtu18339
Sometimes the endpoint will report that it is registered on a H.323 gatekeeper, but
you can't dial anyone. This is due to some problems with additive registrations.
you can't dial anyone. This is due to some problems with additive registrations.
CSCtu18446
- C20 in a call with any other system.
- C20 gets an incoming call.
- C20 accepts call by pressing the disconnect current accept new in GUI.
- C20 gets an incoming call.
- C20 accepts call by pressing the disconnect current accept new in GUI.
- The new call will be audio only.
CSCtu18803
Chinese System name will not be shown in a TANDBERG MPS conference.
CSCtt14285
When configuring SRV base SIP address, the endpoint handles DNS look up with
configured DNS and completes it. However EP does not initiate SIP registration
even if it receives back active A-record response.
configured DNS and completes it. However EP does not initiate SIP registration
even if it receives back active A-record response.
OSD (On Screen Display)
Reference ID
Summary
CSCtu18453
Trying to add another participant in a full MultiSite will not give any OSD warning,
but rather nothing happens at all.
but rather nothing happens at all.
CSCtt14512
The unit will display the encryption status for the last connected call and not for the
entire conference when using MultiSite.
entire conference when using MultiSite.
System
Reference ID
Summary
CSCtu13243
Time will be one hour off during the winter season if Time Zone is set to Russia.
CSCtu42348
The GPIO port available on CTS C40 and CTS C60 is only checked every 5
seconds. If a push button is connected it must be held down for 5 seconds before
the system will read the change of the input.
seconds. If a push button is connected it must be held down for 5 seconds before
the system will read the change of the input.
CSCtu42607
IPv6 DNS addresses are not set up and hence DNS will not work with IPv6.
CSCtu42542
You are not able to call back from the Call History due to the call back number is
incorrect when no H.323ID is supplied by the caller.
incorrect when no H.323ID is supplied by the caller.
CSCtu06798
802.1x is not working
CSCtu42348
The GPIO port available on CTS C40 and CTS C60 is only checked every 5
seconds. If a push button is connected it must be held down for 5 seconds before
the system will read the change of the input.
seconds. If a push button is connected it must be held down for 5 seconds before
the system will read the change of the input.
CSCtr32417
Dual stack for IPv4/IPv6 does not work as intended. If you set the device to IPv6,
you will not be able to reach any s ervices by using an IPv4 address.
you will not be able to reach any s ervices by using an IPv4 address.