Cisco Cisco TelePresence MX700 Nota Di Rilascio
Open caveats
Cisco TelePresence System C/EX/SX/MX Series Software Release Notes
Page 89 of 194
Open caveats
Reference ID
Summary
CSCtz08306*
If non-standard rate is set for default call rate, different rate is used instead of the
rate set when dialing via web or remote.
rate set when dialing via web or remote.
CSCub54863*
SX20 reboots when making or receiving a SIP call when the system clock is set to
1936.
1936.
CSCua08205
Cisco TelePresence Touch 8 may not respond properly to interaction on the
bottom row. NOTE: Some Touch 8 devices will still exhibit this behaviour after
upgrading TC 5.1.3. These panels are defective.
NOTE: This issue was resolved in TC5.1.3 but is reverted in TC5.1.4 and later
due to higher probability of false touch registrations in TC5.1.3
(CSCub65256).
bottom row. NOTE: Some Touch 8 devices will still exhibit this behaviour after
upgrading TC 5.1.3. These panels are defective.
NOTE: This issue was resolved in TC5.1.3 but is reverted in TC5.1.4 and later
due to higher probability of false touch registrations in TC5.1.3
(CSCub65256).
CSCty11069
Dual screen connected to an EX90 is black until you have shared presentation in a
call.
call.
CSCtz87452*
MX, EX, E20, C and SX series endpoints cannot use CUCM phone books with
numbers including white spaces.
numbers including white spaces.
CSCtz77758*
SX20: 1680x1050 VGA input detected as 1400x1050.
CSCtz78809*
In some call scenarios, dual stream will not work in a C-series multisite call
involving MXP (VCS registered) and CUCM registered endpoints such as CTS/C-
series.
involving MXP (VCS registered) and CUCM registered endpoints such as CTS/C-
series.
CSCtz93712
SIP Presentation will fail when Polycom HDX calls a Cisco multisite endpoint.
Cisco endpoint becomes BFCP server and Polycom changes BFCP/TCP port in
re-invite without sending a new BFCP HELLO. Issue will be fixed by upgrading
Polycom to 3.0.5 which uses BFCP over UDP.
Cisco endpoint becomes BFCP server and Polycom changes BFCP/TCP port in
re-invite without sending a new BFCP HELLO. Issue will be fixed by upgrading
Polycom to 3.0.5 which uses BFCP over UDP.
Issues marked with * are resolved in TC6.0.0.