Cisco Cisco TelePresence MX700 Nota Di Rilascio
Resolved caveats
Cisco TelePresence System C/EX/SX/MX Series Software Release Notes
Page 94 of 194
Resolved caveats since TC 5.1.3
Protocol
Reference ID
Summary
CSCub08026
EX90 registered to CUCM, dials in to meeting on TS8710. Call connects and
everything looks fine, but after the endpoint does a Hold/Resume, the EX90 stops
sending audio (but still receives audio).
everything looks fine, but after the endpoint does a Hold/Resume, the EX90 stops
sending audio (but still receives audio).
CSCua84477
If encryption is set to ON for both the MXP and C-series endpoints then oneway
video is experienced on nearly all calls.
video is experienced on nearly all calls.
System
Reference ID
Summary
CSCua98644
When using TC5.1.0 - TC5.1.3 and setting the systems System Name to exactly
50 characters this will result in the system going into a continuous reboot cycle.
50 characters this will result in the system going into a continuous reboot cycle.
CSCua80341
TC 5.x software is sending wrong information for the call in "xfeedback register
status/call" issue with incoming and outgoing call. This causes issues with AMX
control panels.
status/call" issue with incoming and outgoing call. This causes issues with AMX
control panels.
CSCua52818
Usage of GPIO ports on C90/C60 make the codec reboot
Touch 8
Reference ID
Summary
CSCua67474
Calling a H323 contact from touch panel, always dials out using SIP if H323
callsetup mode is Direct.
callsetup mode is Direct.
CSCub65256
Introduction of a new Touch sensor driver in TC5.1.3 may cause false touch
registrations.
registrations.
CSCua38340
When entering Dial Tones quickly on the CT Touch 8, some tones may not be
played back locally even though the DTMF tones are sent and the Dial Tones are
highlighted in the GUI. This may lead to the user entering too many DTMF tones.
NOTE: This issue was not fixed in TC5.1.3 as written in the release notes but is
fixed in TC5.1.4
played back locally even though the DTMF tones are sent and the Dial Tones are
highlighted in the GUI. This may lead to the user entering too many DTMF tones.
NOTE: This issue was not fixed in TC5.1.3 as written in the release notes but is
fixed in TC5.1.4
Web
Reference ID
Summary
CSCub20774
Downloading current logs will not include the files in the log folder, only the files in
the eventlog subfolder
the eventlog subfolder