Cisco Cisco TelePresence MX700 Dépliant

Cisco TelePresence Endpoints and Cisco Unified Communications Manager

Quick Reference Guide

D14996.08 Administering TC7.0 Endpoints on CUCM 9.1.2, AUGUST 2014.

Using the Touch panel

If no menu is displayed on the Touch

controller, tap the display to wake up the

system.

Password protection
The system can be password protected.

Please contact your system administrator if

you can not access the system.

If the system does not wake up:

• Make sure the Touch controller is

connected to the endpoint, either directly

or by the network.

• Make sure the endpoint is connected to

power and switched on.

• If the system has just been switched on,

wait for a few minutes to allow the system

to start up.

• Make sure the Touch controller is properly

paired with the endpoint.

• If in doubt, read the Installation guide for

your product.

Finding the IP address

• Go to (Settings) > System Information

and navigate to the Network section.

Using the remote control

If no menu is displayed on screen, press any

key on the remote control to wake up the

system.

Password protection
The system can be password protected.

Please contact your system administrator if

you can not access the system.

If the system does not wake up:

• Make sure the remote control has working

batteries.

• Make sure the endpoint is connected to

power and switched on.

• If the system has just been switched on,

wait for a few minutes to allow the system

to start up.

• If in doubt, read the Installation guide for

your product.

Finding the IP address

• Go to Home > Settings > System

Information and navigate to the Network

section.

Using the command line interface

When you know the IP address you can

configure the endpoint from a command line

interface by API commands.

Signing in through SSH

1. Start a command line interface (for

example PuTTY). Enter the host name

(or IP address) of the codec and set

connection type to SSH.

2. Enter your user name and password to

If you are not able to connect to the system:

• Make sure the endpoint and computer are

connected to the same network.

• Make sure the endpoint is connected to

power and switched on.

• If the system has just been switched on,

wait for a few minutes to allow the system

to start up.

• If in doubt, read the Installation guide for

your product.

Using the web interface

When you know the IP address you can

configure the endpoint from the web

interface.

Signing in to the web interface

1. Open a web browser and enter the

system’s IP address in the address bar.

2. Enter your user name and password and

click Sign In.

If you are not able to connect to the system:

• Make sure the endpoint and computer are

connected to the same network.

• Make sure the endpoint is connected to

power and switched on.

• If the system has just been switched on,

wait for a few minutes to allow the system

to start up.

• If in doubt, read the Installation guide for

your product.

The TelePresence endpoint user interfaces

You can use the Touch controller, the remote control, the web interface, or the command line

interface to configure the endpoint.

NOTE:

Access through HTTP (web interface) and SSH (command line interface) will be disabled

when the endpoint has been succesfully registered to Cisco Unified CM 9.1.1 (using a dev.pack

with support for TC6.3).

Contents

Introduction

CUCM configuration

Endpoint configuration

About passwords

Appendices