Cisco Cisco TelePresence MX700 Dépliant

Cisco TelePresence Endpoints and Cisco Unified Communications Manager

Quick Reference Guide

D14996.06 Administering TC6.3 Endpoints on CUCM 9.1.2, OCTOBER 2013.

Verifying the endpoint registration

After having provisioned the endpoint to CUCM you should

verify that the registration was successful.

Making a call

Make a call from the TelePresence endpoint to see if the

registration was successful.

Use the interface of your choice:

•  The touch controller
•  The remote control
•  The web interface
•  The command line interface

Checking the system information

When checking the system information, the

SIP Status

should show Registered and the

SIP Proxy should display the

address of the CUCM.

Using the web interface
Navigate to Home > System Information and see the SIP

section.

Using the Touch controller
Tap (Settings) > System Information on the Touch and see

the SIP section.

Using the remote control
Navigate to Home > Settings > System Information and see

the SIP section.

Using the command line interface
Open a command line interface (e.g. PuTTY), log in to the

endpoint (codec), and run the following API commands:

xStatus SIP Profile 1 Registration 1 Status
xStatus SIP Proxy 1 Address
or:

xStatus SIP - to see a complete overview.

Contents

Introduction

CUCM configuration

Endpoint configuration

About passwords

Appendices

Endpoint configuration