Cisco Cisco TelePresence MX700 Dépliant
524: Are there any shortcuts on the TRCV remote control?
The following remote control shortcuts are available:
Quick access
y
Home menu
: Press the
OK / V key when no menus are shown (same as pressing the
home key in any menu).
y
System Information and Call status
: Press the
right-most function key on the
home
menu.
y
Advanced Configuration
: Press the
fourth function key (from left) on the
System
Information and Call status
page. The quick key sequence is "
home- right-most
function key - fourth function key" (or "V- right-most function key - fourth function
key" when no menus are shown).
Quick Call
y
Call menu
: Press any
number key in idle mode (when not in a call).
y
Recent calls
: Press the
call key when the
Call
menu is not visible.
y
Dial last number
: Press the
call key twice.
Camera Control
y
Camera control soft menu
: Press any
arrow or zoom key in idle mode.
y
Camera presets
: Press the
number key corresponding to the desired camera preset
on the
Camera control
soft menu to change preset.
Other
y
Standby mode
: Press and hold the
Disconnect-key for 5 seconds.
y
Restore resolution and OSD
: When not in a call, enter the sequence following sequence
with the remote control "
Disconnect-key - * - # - * - # - 0 - x - #" where x is output
1 to 4 to change the OSD and restore the resolution (1280×720@60Hz for HDMI and
1024×768@60Hz for DVI) to the selected output.
y
DTMF
: Pressing a
number key in a call gives the DTMF (Dual Tone Multiple Frequencies)
sound for the pressed number.
Applies to the following products:
y
SX20 Quick Set
y
Codec C20
y
Codec C40
y
Codec C60
y
Codec C90
Related questions:
302: How do I change the output for my On Screen Display (OSD) from HDMI1 to another
output when the system is used with the TRCV remote control?
528: Which resolutions do the video systems support at 60 fps?
The supported resolutions at
60 fps are w288, w448, w576 and w720.
Please note the following:
y
The Cisco TelePresence Codec
C20, SX20, MX200, MX300 and EX60 can encode
60 fps in point-to-point calls, but not if a presentation is running at the same time.
y
The Cisco TelePresence Codec
C40, C60 and EX90 can encode 60 fps in point-to-
point calls, also when presentations are running at the same time, but not in MultiSite.
y
The Cisco TelePresence Codec
C90 can encode 60 fps in point-to-point calls, when
running presentations, and in MultiSite.
Applies to the following products:
y
SX20 Quick Set
y
Codec C20
y
Codec C40
y
Codec C60
y
Codec C90
y
MX200
y
MX300
y
EX60
y
EX90
Related questions:
530: What is the relationship between transmitted frame rate and bandwidth on the video
systems?
Cisco TelePresence TC Endpoints
D14865.03 TC Endpoints Knowledge Base Articles | APRIL 2015
Copyright © 2011–2013 Cisco Systems, Inc. All rights reserved.
16
Knowledge Base Articles
Contents
Introduction
Questions
Contact
Questions and answers
Appendices
Questions and answers