Cisco Cisco Aironet 701e Access point Guida All'Installazione
9
d.
After the access point finds the Cisco wireless LAN controller, it attempts to download the
new operating system code if the access point code version differs from the Cisco wireless
LAN controller code version. While this is happening, the Status LED blinks dark blue.
new operating system code if the access point code version differs from the Cisco wireless
LAN controller code version. While this is happening, the Status LED blinks dark blue.
e.
If the operating system download is successful, the access point reboots.
Step 3
Configure the access point if required. Use the controller CLI, controller GUI, Cisco Prime
Infrastructure, Cisco NCS, or Cisco Prime Infrastructure to customize the
access-point-specific network settings.
Infrastructure, Cisco NCS, or Cisco Prime Infrastructure to customize the
access-point-specific network settings.
Step 4
If the pre-installation configuration is successful, the Status LED is green indicating normal
operation. Disconnect the access point and mount it at the location at which you intend to
deploy it on the wireless network.
operation. Disconnect the access point and mount it at the location at which you intend to
deploy it on the wireless network.
Step 5
If your access point does not indicate normal operation, turn it off and repeat the
pre-installation configuration.
pre-installation configuration.
Note
When you are installing a Layer 3 access point on a different subnet than the Cisco
wireless LAN controller, be sure that a DHCP server is reachable from the subnet on
which you will be installing the access point, and that the subnet has a route back to
the Cisco wireless LAN controller. Also be sure that the route back to the Cisco
wireless LAN controller has destination UDP ports 5246 and 5247 open for CAPWAP
communications. Ensure that the route back to the primary, secondary, and tertiary
wireless LAN controller allows IP packet fragments. Finally, be sure that if address
translation is used, that the access point and the Cisco wireless LAN controller have
a static 1-to-1 NAT to an outside address. (Port Address Translation is not
supported.)
wireless LAN controller, be sure that a DHCP server is reachable from the subnet on
which you will be installing the access point, and that the subnet has a route back to
the Cisco wireless LAN controller. Also be sure that the route back to the Cisco
wireless LAN controller has destination UDP ports 5246 and 5247 open for CAPWAP
communications. Ensure that the route back to the primary, secondary, and tertiary
wireless LAN controller allows IP packet fragments. Finally, be sure that if address
translation is used, that the access point and the Cisco wireless LAN controller have
a static 1-to-1 NAT to an outside address. (Port Address Translation is not
supported.)
7
Mounting the Access Point
Cisco Aironet 701E access point can be mounted in several configurations, including on a suspended
ceiling, on a hard ceiling or wall, or on an electrical or network box. Mounting equipment is sold
separately.
ceiling, on a hard ceiling or wall, or on an electrical or network box. Mounting equipment is sold
separately.
The AP-701E is compatible with the AIR-AP-BRACKET-7=. If this bracket is used then the following
can also be used: AIR-AP-T-RAIL-F=, AIR-AP-T-RAIL-R= and AIR-AP-CHNL-ADAPTER=.
Mounting accessories are sold separately. For more information on brackets available of use, go to the
URL
can also be used: AIR-AP-T-RAIL-F=, AIR-AP-T-RAIL-R= and AIR-AP-CHNL-ADAPTER=.
Mounting accessories are sold separately. For more information on brackets available of use, go to the
URL