Cisco Cisco SG200-26P 26-port Gigabit PoE Smart Switch Manuale Di Manutenzione

Setting the Default VLAN

Cisco Small Business SF200E Series Advanced Smart Switch

119

 

•

PVID—When this option in selected, the port uses the selected VLAN ID as 
its port VLAN ID (PVID). The port assigns the PVID to all untagged frames 
received on the port before forwarding. The following configuration rules 
apply:

-

If the interface VLAN mode is General, any VLAN of which the interface is 
a Tagged or Untagged member can be selected to provide the PVID. 

-

If the interface VLAN mode is Trunk, the PVID is set to the VLAN ID of 
which the port is a tagged member.

-

If the interface VLAN type is Access, the PVID is set to the Access VLAN 
ID and this field cannot be modified.

When you select the Untagged, Tagged, and PVID options and move the VLAN to 
the Selected list, a U, T, and/or P is appended to the VID.

Click Apply and then click Close. Your changes are saved to the Running 
Configuration.

By default, the switch automatically creates VLAN 1 as the default VLAN for all 
ports and link aggregation groups (LAGs). If a port has no VLAN memberships, the 
switch automatically configures it as a member of the default VLAN. 

You can use the Default VLAN Settings page to change the default VLAN.

When the VID of the default VLAN is changed:

•

Ports that were members of the original default VLAN are removed as 
members of that VLAN and are configured as members of the new default 
VLAN.

•

The Port VLAN Identifier (PVID) of the ports that were members of the 
original default VLAN is changed to the VID of the new default VLAN.

•

If the management VLAN was the same as the original default VLAN, then 
the management VLAN is updated to the new default VLAN provided there 
is at least one member port. If DHCP is enabled, the switch attempts to 
renew the switch IP address through DHCP.