Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
Exec Modes Commands (D-S)
ping ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22948-01
ping
Verifies ability to communicate with a remote node in the network by passing data packets between and measuring the
response.
response.
Product
All
Privilege
Security Administrator, Administrator, Operator, Inspector
Important:
Inspector privileges are granted for all variables except count. To initiate a ping count, you must
have a minimum privilege level of Operator.
Syntax
Identifies the remote node to which the ability to communicate with is to be verified.
: specifies the remote node using the node‘s assigned IP address specified using the
standard IPv4 dotted decimal notation.
Sends ping packets to broadcast addresses.
Default: 5
Specifies the number of packets to send to the remote host for verification.
Specifies the number of packets to send to the remote host for verification.
must be within
the range 1 through 10000.
Default: each octet of the packet is encoded with the octet number of the packet.
Specifies a pattern to use to fill the internet control message protocol packets with.
Specifies a pattern to use to fill the internet control message protocol packets with.
must
be specified in hexadecimal format with a value in the range hexadecimal 0x0000 through 0xFFFF.
must begin with a ‗0x‘ followed by up to 4 hexadecimal digits.
Default: 56
Specifies the number of bytes each IP datagram.
Specifies the number of bytes each IP datagram.
must be a value in the range 40 through
18432.
Default: originating system‘s IP address
Specifies an IP address to use in the packets as the source node.
Specifies an IP address to use in the packets as the source node.