Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
GGSN Service Configuration Mode Commands
▀ policy
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
policy
Specifies the reject code to be used in the "Create PDP Context" response message when a RADIUS server timeouts.
Product
GGSN
Privilege
Security Administrator, Administrator
Syntax
Restores the specified parameter to its default setting.
Default:
Specifies the reject code used by the GGSN if communication with an accounting server times out. The
possible reject codes are:
possible reject codes are:
system-failure (204 (CCH))
no-resources (199 (C7H))
Default: user-authentication-failure
Specifies the reject code used by the GGSN if communication with an authentication server times out. The
possible reject codes are:
Specifies the reject code used by the GGSN if communication with an authentication server times out. The
possible reject codes are:
system-failure (204 (CCH))
user-authentication-failure (209 (D1H))
Usage
This command is used to configure the cause code used by the GGSN if communication with either a
RADIUS authentication or accounting server times out.
When this parameter is used in conjunction with Radius accounting servers, the response is only set if a flag
is configured in the APN Delay GTP Response, only after getting a response to the Accounting Start.
RADIUS authentication or accounting server times out.
When this parameter is used in conjunction with Radius accounting servers, the response is only set if a flag
is configured in the APN Delay GTP Response, only after getting a response to the Accounting Start.
Example
The following command configures the GGSN response to a RADIUS authentication server timeout to be system-
failure:
The following command configures the GGSN response to a RADIUS authentication server timeout to be system-
failure: