Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
Global Configuration Mode Commands
▀ congestion-control overload-disconnect
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
congestion-control overload-disconnect
This command enables and disables the policy for disconnecting passive calls (chassis-wide) during an overload
situation. It also configures and fine-tunes the overload-disconnect congestion control policy for an entire chassis.
situation. It also configures and fine-tunes the overload-disconnect congestion control policy for an entire chassis.
To verify the congestion-control configuration use
from the
Exec mode.
To set overload-disconnect policies for individual subscribers., see
in Subscriber
Configuration Mode Commands.
Product
All
Privilege
Security Administrator, Administrator
Syntax
An integer between 2 and 8. This value defines the number of calls to be disconnected during the defined
number of seconds. The default value for this keyword is 8.
number of seconds. The default value for this keyword is 8.
An integer between 1 and 100 specifies the percentage of calls to be disconnected, in stages, during an
overload situation. The default value is 5.
overload situation. The default value is 5.
An integer value between 1 and 100 that specifies the license-utilization
percentage threshold for overload situations. If candidates are available, passive calls are disconnected when
this threshold is exceeded. The default value is 80.
this threshold is exceeded. The default value is 80.
An integer value between 1 and 100 that specifies a
percentage of the maximum sessions per service. If candidates are available, passive calls are disconnected
when this threshold is exceeded. The default value is 80.
when this threshold is exceeded. The default value is 80.
An integer between 1 and 25 that specifies the percentage of calls the system disconnects
below the values set for the other two thresholds. In either case, a Clear Traps message is sent after the
number of calls goes below the corresponding threshold value. The tolerance default value is 10.
number of calls goes below the corresponding threshold value. The tolerance default value is 10.
When ‗default‘ and one of the keywords is added to the command, then the policy remains in its current state
and the value for the specified keyword is reset to its default value.
and the value for the specified keyword is reset to its default value.