Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
HNB-GW Service Configuration Mode Commands
▀ sctp
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
sctp
This command configures the SCTP IP address and port that will be used for binding the SCTP socket to communicate
with the Home-NodeB over Iuh interface with an HNB-GW service.
with the Home-NodeB over Iuh interface with an HNB-GW service.
Product
HNB-GW
Privilege
Security Administrator, Administrator
Syntax
Sets the SCTP port to default value of 600 to communicate with the Home-NodeB using Iuh interface.
Specifies the IP address of HNB-GW in IPv4 or IPv6 notation for the interface configured as Iuh interface to
connect with Home-NodeB.
connect with Home-NodeB.
must be an IP address in IPv4 or IPv6 notation.
Specifies the SCTP port number to communicate with the Home-NodeBs using Iuh interface.
must be an integer between 1 through 65535.
Usage
Use this command to assign the SCTP IP address and port with SCTP socket on HNB-GW to communicate
with the Home-NodeB using Iuh interface. This SCTP configuration provides the IP-address and listen port
where HNB-GW service shall bind to listen for incoming SCTP associations from HNB.
with the Home-NodeB using Iuh interface. This SCTP configuration provides the IP-address and listen port
where HNB-GW service shall bind to listen for incoming SCTP associations from HNB.
Example
The following command sets the SCTP port number
The following command sets the SCTP port number
on HNB-GW to listen from Home-NodeB over Iuh interface:
The following command sets the SCTP address
of HNB-GW to use with Home-NodeB over Iuh interface: