Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
Active Charging Service Configuration Mode Commands
firewall flow-recovery ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22948-01
firewall flow-recovery
This command configures Stateful Firewall Flow Recovery settings.
Product
FW
Privilege
Security Administrator, Administrator
Syntax
Configures the default setting.
Default: downlink and uplink recovery is enabled, 300 seconds
Default: downlink and uplink recovery is enabled, 300 seconds
Disables the previous configuration.
Specifies the packets:
: Enables flow recovery for packets from downlink direction.
: Enable flow recovery for packets from uplink direction.
Specifies the Stateful Firewall Flow Recovery Timeout setting, in seconds.
must be an integer from 1 through 86400.
Default: 300 seconds
Specifies not to create data session/flow-related information for downlink-initiated packets (from the Internet
to the subscriber) while the firewall downlink flow-recovery timer is running, but send to subscriber.
to the subscriber) while the firewall downlink flow-recovery timer is running, but send to subscriber.
Usage
Use this command to configure Stateful Firewall Flow Recovery.
Important:
NAT flows will not be recovered.
Example