Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
MME Service Configuration Mode Commands
▀ emm
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
emm
This command defines the Evolved Mobility Management timer parameters like timeout durations for timers for the
NAS message retransmission in MME service.
NAS message retransmission in MME service.
Product
MME
Privilege
Security Administrator, Administrator
Syntax
Resets the specified timer timeout to the system default value.
Removes the specified EMM timeout definition from the configuration.
Default: 5640
Sets the timer timeout duration after which subscriber will implicitly detached from the network if there is no
activity. Generally this timer value is 240 seconds (4 minutes) more than the timeout value of T3423 timer.
This timer starts when mobile reachable timer expires while the network is in EMM-IDLE mode and ISR is
activated and stops when NAS signalling connection established.
Sets the timer timeout duration after which subscriber will implicitly detached from the network if there is no
activity. Generally this timer value is 240 seconds (4 minutes) more than the timeout value of T3423 timer.
This timer starts when mobile reachable timer expires while the network is in EMM-IDLE mode and ISR is
activated and stops when NAS signalling connection established.
is timeout duration in seconds and must be an integer from 1 through 12000.
Default: 5640
Sets the timeout timer duration after which reachability procedure will be discarded and reattempt starts.
Sets the timeout timer duration after which reachability procedure will be discarded and reattempt starts.
is timeout duration in seconds and must be an integer from 1 through 12000.
Default: 5400
Sets the timeout duration for T3412 timer. This timer is used for periodic tracking area update (P-TAU).
When this timer expires, the periodic tracking area updating procedure starts and the timer is set to its initial
value for the next start.
This timer starts when the UE goes from EMM-CONNECTED to EMM-IDLE mode and stops when the UE
enters EMM-CONNECTED mode.
Sets the timeout duration for T3412 timer. This timer is used for periodic tracking area update (P-TAU).
When this timer expires, the periodic tracking area updating procedure starts and the timer is set to its initial
value for the next start.
This timer starts when the UE goes from EMM-CONNECTED to EMM-IDLE mode and stops when the UE
enters EMM-CONNECTED mode.
is timeout duration in seconds and must be an integer from 1 through 11160.
Default: 10