Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
Route-map Configuration Mode Commands
▀ set origin
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
set origin
This command sets the BGP origin code to the specified value. This command is for route maps that are used with BGP
routing only.
routing only.
Product
HA
Privilege
Security Administrator, Administrator
Syntax
Disables setting the origin code.
Set the origin code to specify that the path is from a remote External Gateway Protocol (EGP) system.
Set the origin code to specify that the path is from a local Interior Gateway Protocol (IGP) system.
Set the origin code to specify that the path is from an unknown system.
Usage
Use this command to set a specified origin code for BGP.
Example
To the origin code to EGP, enter the following command:
set origin egp
To the origin code to EGP, enter the following command:
set origin egp