Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
APN Configuration Mode Commands
▀ loadbalance-tunnel-peers
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
loadbalance-tunnel-peers
Configures how tunnel-peers are selected for this APN.
Product
GGSN, P-GW
Privilege
Security Administrator, Administrator
Syntax
Default: Disabled
Tunnel-peer selection is made without regard to prioritization, but in a sequential order that balances the load
across the total number of peer nodes available.
Tunnel-peer selection is made without regard to prioritization, but in a sequential order that balances the load
across the total number of peer nodes available.
Default: Disabled
Tunnel-peer selection is made based on the priority configured for the peer.
Tunnel-peer selection is made based on the priority configured for the peer.
Default: Enabled
Tunnel-peer selection is random in order.
Tunnel-peer selection is random in order.
Usage
Use this command to configure the load-balancing algorithm that defines how the tunnel-peers are selected
by the APN when multiple peers are configured in the APN.
by the APN when multiple peers are configured in the APN.
Example
The following command sets the APN to connect to tunnel-peers in a sequential order:
The following command sets the APN to connect to tunnel-peers in a sequential order: