Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
Service Redundancy Protocol Configuration Mode Commands
▀ priority
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
priority
Sets the initial Interchassis Session Recovery priority of each peer chassis.
Important:
takes affect only during simultaneous initializing of all chassis in an Interchassis Session
Recovery configuration, and only if a misconfiguration has both chassis in the same mode (both Primary or both
Backup).
Backup).
Product
HA, GGSN
Privilege
Security Administrator, Administrator
Syntax
Resets the priority to the default setting of 125.
The priority for the HA.
must be an integer from 1 through 255.
Usage
This command determines which chassis transitions to the Active state when all chassis have the same mode
configuration.
configuration.
acts as a tie breaker for the state determination only when all chassis initialize
simultaneously. The chassis with the higher priority (higher number) becomes Active while the chassis with
the lower priority (lower number) becomes Standby.
Once chassis become operational (after initialization), if there is an event requiring a chassis change of state,
then each chassis returns to its previous state (Active or Standby) after both chassis recover.
the lower priority (lower number) becomes Standby.
Once chassis become operational (after initialization), if there is an event requiring a chassis change of state,
then each chassis returns to its previous state (Active or Standby) after both chassis recover.
Example