Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
Subscriber Configuration Mode Commands
content-filtering category ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22948-01
content-filtering category
This command enables/disables the specified preconfigured Category Policy Identifier for policy based Content
Filtering support to the subscriber.
Filtering support to the subscriber.
Product
All
Privilege
Security Administrator, Administrator
Syntax
Disables the configured category policy identifier for Content Filtering support to the subscriber. This is the
default setting.
default setting.
This command applies the content filtering category policy ID, configured in Active Charging Configuration
mode, to this subscriber.
mode, to this subscriber.
must be a preconfigured category policy id in Active Charging Configuration Mode.
In case category policy identifier
used here is not configured in Active Charging
Configuration Mode, all packets will be passed regardless of the categories determined for such packets.
Important:
Category Policy Id configured through this mode overrides the Category Policy id configured
through
command in Rulebase Configuration Mode of Active
Charging Service Configuration mode.
Usage
Use this command to enter the Content Filtering Policy Configuration mode and to enable or disable the
Content Filtering Category Policy ID for a Subscriber.
Content Filtering Category Policy ID for a Subscriber.
Important:
If Content Filtering Category Policy ID is not specified here the similar command in Rulebase
Configuration Mode of Active Charging Configuration Mode determines the policy.
Up to 64 different policy identifier can be defined in a Content Filtering support service.
Example
Following command enters the Content filtering Policy Configuration mode and enables the Category Policy Id
Following command enters the Content filtering Policy Configuration mode and enables the Category Policy Id
for
Content Filtering support.