Cisco Cisco Packet Data Interworking Function (PDIF) Guida Alla Risoluzione Dei Problemi
Context Configuration Mode Commands
lawful-intercept ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22948-01
keep connection live. This keyword is used to enable/disable sending of heart beat messages. By
default this mode is disabled
default this mode is disabled
sets the timeout duration for heartbeat timer. By default heart beat timer
value is 5 minutes.
- configures the maximum time to wait before retrying to
connect, in seconds. Default is 2 seconds.
enter any integer from 1 to 65535.
- configures the destination IP address of the
DF3 to send the intercepted content (ie: data/CC).
enter an address in standard
IPv4/IPv6 format. Must be followed by:
- configures the destination port where the intercepted information
is to be forwarded.
enter any integer from 1 to 65535.
- configures the destination address of the DF2 to
send the intercepted events information (ie: IRI).
enter an address in standard
IPv4/IPv6 format. Must be followed by:
- configures the destination port where the intercepted information
is to be forwarded.
enter any integer from 1 to 65535.
This set of keywords instructs the system to use the service-address, in place of the source-address in the ip-
headers of the intercepted messages that are forwarded to the DF according to the content delivery
provisioning done in the Exec configuration mode. The service-address is an IPv4 address that identifies on
which of the system‘s interfaces the intercept was received.
headers of the intercepted messages that are forwarded to the DF according to the content delivery
provisioning done in the Exec configuration mode. The service-address is an IPv4 address that identifies on
which of the system‘s interfaces the intercept was received.
Important:
This function requires that the Lawful Intercept provisioning (done in the Exec configuration mode)
include the
for the
keyword. Changing the configuration and the
provisioning to enable/disable this feature can be done on the fly.
Usage
Use this command to configure the parameters controlling the forwarding of the intercepted messages to the
DF.
For details on provisioning the Lawful Intercepts, refer to the Exec configuration mode.
For details on using the Lawful Intercept capability of the system, refer to System Administration and
Configuration Guide.
DF.
For details on provisioning the Lawful Intercepts, refer to the Exec configuration mode.
For details on using the Lawful Intercept capability of the system, refer to System Administration and
Configuration Guide.
Important:
When monitoring for calls that are not yet active, the source-address information does not need to be
configured immediately. However, it must be configured as soon as the call becomes active in order for Lawful
Interception to function properly.
Interception to function properly.
Example
To set the source-address in the current context to 198.162.100.10, use the following command:
To set the source-address in the current context to 198.162.100.10, use the following command: