Cisco Cisco Packet Data Interworking Function (PDIF) Guida Alla Risoluzione Dei Problemi
ACL Configuration Mode Commands
▀ redirect css service (for uplink, by TCP/UDP packets)
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
Specifies that all destination TCP port numbers less than the one specified are to be filtered.
must be configured to any integer value from 0 to 65535.
Specifies that all destination TCP port numbers not equal to the one specified are to be filtered.
must be configured to any integer value from 0 to 65535.
Specifies that all destination TCP ports within a specific range are to be filtered.
is the initial port in the range and
is the final port in the range.
Both
and
can be configured to any integer value from 0 to 65535.
Usage
Block IP packets when the source and destination are of interest but for only a limited set of ports.
Example
The following command defines a rule definition that redirects packets to the charging service named
The following command defines a rule definition that redirects packets to the charging service named
, and
UDP packets coming from any host are matched.
The following sets the insertion point before the rule definition above.
redirect
udp any
The following command sets the insertion point after the first rule definition above.
redirect
udp any
The following deletes the rule definition above.
redirect
udp any