Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
ASN Gateway Service Configuration Mode Commands
bs-monitor ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
bs-monitor
Use this command to enable or disable the ASN base station monitoring and related parameters in a WiMAX ASN.
Product
ASN GW
Privilege
Administrator
Syntax
Disables the configured BS monitoring parameters.
Removes the configured BS monitoring feature and parameters.
Default: 60
Configures the interval duration in seconds between two ICMP ping messages sent to the ASN BS for BS
monitoring.
Configures the interval duration in seconds between two ICMP ping messages sent to the ASN BS for BS
monitoring.
specifies the amount of time in seconds between two ICMP ping messages sent to monitor an
ASN BS. Specify an integer from 1 through 36000.
Default: 5
Configures the number of retries before marking a specific ASN BS as unreachable.
Configures the number of retries before marking a specific ASN BS as unreachable.
specifies the number of times to send ICMP ping messages to an ASN BS before the ASN BS is
declared unreachable. Enter an integer from 0 through 100.
Default: 3
Configures the timeout duration to wait for a response from ASN BS of ICMP ping message before
retransmitting the ICMP ping packets.
Configures the timeout duration to wait for a response from ASN BS of ICMP ping message before
retransmitting the ICMP ping packets.
must be an integer value in the range of 1 through 10.
Usage
Use this command to enable or disable base station monitoring and to configure the ASN BS monitoring
parameters in a WiMAX ASN.
parameters in a WiMAX ASN.
Important:
Base Station Monitoring is a license-enabled feature.