Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
CSCF Signalling Compression Configuration Mode Commands
compression-mode ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
compression-mode
Configures the dynamic compression mode to be used while sending a SigComp message. Simple dynamic mode is the
default.
default.
Product
SCM
Privilege
Administrator
Syntax
Default:
: A maximum of four dynamic states will be created per compartment. The dynamic
states are updated for each message by deleting the oldest dynamic state and creating the new one. The
dynamic states will be updated in FIFO (First In, First Out) order.
dynamic states will be updated in FIFO (First In, First Out) order.
: Only one dynamic state will be created per compartment. The same state will be used
for compression.
: No dynamic states will be created. Only static dictionary will be used for compression.
update-dynamic: Only one dynamic state will be created per compartment, but the dynamic state will be
updated for every new message.
updated for every new message.
Returns the dynamic compression mode to simple dynamic.
Usage
Use this command to configure the dynamic compression mode to be used.
Example
The following command sets the compression mode to multiple dynamic:
The following command sets the compression mode to multiple dynamic:
The following command completely disables the creation of dynamic states for compression: