Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
DHCP Service Configuration Mode Commands
max-retransmissions ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
max-retransmissions
Configures the maximum number of times that the system attempts to communicate with unresponsive DHCP server
before it is considered a failure.
before it is considered a failure.
Product
GGSN, ASN-GW
Privilege
Security Administrator, Administrator
Syntax
Default: 5
Specifies the maximum number of re-attempts the system tries when no response is received from a DHCP
server.
Specifies the maximum number of re-attempts the system tries when no response is received from a DHCP
server.
can be configured to any integer value from 1 to 20.
Usage
This command works in conjunction with the dhcp detect-dead-server parameter to set a limit to the number
of communication failures that can occur with a configured DHCP server.
When the value specified by this parameter is met, a failure is logged. The dhcp detect-dead-server parameter
specifies the number of consecutive failures that could occur before the server is marked as down.
In addition, the
of communication failures that can occur with a configured DHCP server.
When the value specified by this parameter is met, a failure is logged. The dhcp detect-dead-server parameter
specifies the number of consecutive failures that could occur before the server is marked as down.
In addition, the
command controls the amount of time between re-tries.
Example
The following command configures the maximum number of times the system re-attempts communication with a DHCP
server that is unresponsive to 5:
The following command configures the maximum number of times the system re-attempts communication with a DHCP
server that is unresponsive to 5: