Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
DHCP Service Configuration Mode Commands
▀ T2-threshold
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
T2-threshold
Configures the DHCP T2 timer as a percentage of the allocated IP address lease.
Product
GGSN, ASN-GW
Privilege
Security Administrator, Administrator
Syntax
Default: 88%
The percentage of the allocated IP address lease time at which the DHCP call-line state is changed to
―REBINDING‖. It can be configured to any integer value from 67 to 99%.
The percentage of the allocated IP address lease time at which the DHCP call-line state is changed to
―REBINDING‖. It can be configured to any integer value from 67 to 99%.
Usage
This command is used to identify the time at which a subscriber re-binds their DHCP leased IP address as a
percentage of the overall lease time. (Refer to the
percentage of the overall lease time. (Refer to the
command in this chapter for
information on configuring the IP address lease period.)
For example, if the lease-duration was configured to have a maximum value of 12000 seconds, and this
command is configured to 70%, then the subscriber would enter the REBINDING state after 8400 seconds.
For example, if the lease-duration was configured to have a maximum value of 12000 seconds, and this
command is configured to 70%, then the subscriber would enter the REBINDING state after 8400 seconds.
Example
The following command configures the T1 threshold to 70%:
The following command configures the T1 threshold to 70%: