Cisco Cisco Packet Data Gateway (PDG) Guida Alla Risoluzione Dei Problemi
Ethernet Interface Configuration Mode Commands
▀ port-switch-on-L3-fail
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
port-switch-on-L3-fail
This command causes the line card port to which the current interface is bound to switch over to the port on the
redundant line card when connectivity to the specified IP address is lost.
redundant line card when connectivity to the specified IP address is lost.
Product
All
Privilege
Security Administrator, Administrator
Syntax
Disable port switchover on failure.
The IP address to monitor for connectivity. ‗ ip_address must be in either ipv4 format or IPv6 format
Default: 120 seconds
After a switchover occurs, another switchover cannot occur until the amount of time specified has elapsed.
After a switchover occurs, another switchover cannot occur until the amount of time specified has elapsed.
must be an integer in the range from 1 to 3600.
Default: 60 seconds
This specifies how often, in seconds, monitoring packets are sent to the IP address being monitored.
This specifies how often, in seconds, monitoring packets are sent to the IP address being monitored.
must be an integer in the range from 1 to 3600.
Default: 3 seconds
This specifies how long to wait without a reply before resending monitoring packets to the IP address being
monitored.
This specifies how long to wait without a reply before resending monitoring packets to the IP address being
monitored.
must be an integer in the range from 1 to 10.
Default: 5
This value specifies how many times to retry sending monitor packets to the IP address being monitored
before performing the switchover operation.
This value specifies how many times to retry sending monitor packets to the IP address being monitored
before performing the switchover operation.
must be an integer in the range from 1 to 100.
Usage